SpikeTestCase Properties

Gets or sets the total iterations expected at the moment X

Gets or sets the cycles ignored.

Gets or sets the total iterations have been launched during the test at the moment X

Gets or sets the actual load graph for the last execution, it can be compared to theoretic load.

Gets or sets the test case level Context values. The context is dispatched by the automation engine, and is read-only outside of the Test Cases.

Gets or sets the cpu usage measurement of the last execution

Gets a list of custom variables defined by the user. These variables will be saved with the project. and will be replaced if necessary. CustomVariables are more priority than variables in Variables, if an variable of the same name exists both in CustomVariables and Variables, the value of that in CustomVarialbes will return.

Gets or sets the delay to start the test execution.

Gets or sets the Description of the current AbstractTestItem

Gets or sets the information can be shown to the user

Gets or sets the duration in number of the second where this test scenario will last.

A DateTime object indicates the time when current steps finishes. EndTime is set by the test framework after the Checkpoint method has finishes. If the test step goes wrong, EndTime will be set when the error occurs.

Gets or sets the expected number of iterations per second during the performance testing

Gets or sets the expected peak load. The peak load must greater or equals to ExpectedLoad

Gets or sets the unique identifier of the TestCase.

Gets or sets whether the current test item is disabled.

Gets or sets a value indicating whether this item is extended in its Visual Tree.

Gets or sets the iteration execution time during the last execution.

Gets or sets the iteration pass rate during the last execution

Gets or sets the level of log details in a performance test report

Gets or sets the number of measure points to calculate performance counters;

Gets or sets the memory usag measurement during the last execution

Gets or sets the name of this Test Case

Gets or sets number of peak loads during the test. Performance test engine will generate this number of peak loads during the test.

Gets or sets the behavior of Automation Engine when the current test case fails

Gets or sets the performance thresholds of the current load test

Gets or sets the progress of the current test item (Test suite or test case)

Gets or sets the time of ramp up in seconds that passes from 0 to expected load.

Gets the status of the current performance test scenario

Gets or sets the service names dictionary

Gets or sets the pass rate operation by operation during the last execution. Only request operations are measured.

Gets or sets the service response time.

Gets or sets the duration of peak load.

A DateTime object indicates the time when current steps starts to run. StartTime is set by the test framework when the Run method has been called.

Status of the current test item (TestSuite, TestCase or TestStep). Automation framework will mark Result = Running when entering the current item. If Result has not been changed in Run() and Checkpoint() method, it will be marked as Passed.

You must assign Errors, Warning if it happens within Run and Checkpoint method.

Gets or sets a list of Test Steps. The test steps will be executed

Gets the count of test steps

Gets or sets the referenced test suite.

Gets or sets the variables in the current test scope (Test Step, Test Case or Test Suite).